ROADWARE 10 CONCRETE MENDER™ 300ML X 300ML CARTRIDGE APPLICATION INSTRUCTIONS
	Home - Products - Applications - Sales Literature - E-mail Roadware
Tools Required Cartridge Assembly Start-up Procedure Crack and Joint Repair Spall Repair  Recapping Partial Cartridges Troubleshooting, Clean-up and Disposal

Recapping Partial Cartridges

Hold cartridge sideways over a waste container and remove retaining nut, mixer, and Flow Controller.
Bleed off a few drops of material to clear out any cured product. Clean Flow Controller and save for future use or replace.
Hold cartridge upright and place D-rings into the top ports. Place overcap on cartridge. Store upright in a cool, dry place. Material will remain usable for a varying amount of time depending on the moisture level of the storage. Signs of moisture contamination are heavy caking and crystallization of the A-side material at the D-rings and the rear seals. To reuse cartridge, follow normal start-up procedures.

Tools Required

Cartridge Assembly

Start-up Procedure

Crack and Joint Repair

Spall Repair

Recapping Partial Cartridges

Troubleshooting, Clean-up and Disposal

Home - Products - Applications - Sales Literature - E-mail Roadware

©2001 Roadware Incorporated, All Rights Reserved, The information within this website is for the sole use of Roadware customers and interested parties. Alteration and duplication is prohibited without written consent from Roadware, Inc.