Roadware 10 Minute Concrete Mender Instructions Page 5

ROADWARE 10 CONCRETE MENDER™

300ML X 300ML CARTRIDGE APPLICATION INSTRUCTIONS

Home - Products - Applications - Sales Literature - E-mail Roadware

Tools Required

Cartridge Assembly

Start-up Procedure

Crack and Joint Repair

Spall Repair

Recapping Partial Cartridges

Troubleshooting, Clean-up and Disposal

Spall Repair

1) Clean repair area. Remove all dirt, oils, and loose debris. Make a 1/4" relief cut with grinder.

2) Remove any dust with a vacuum or compressed air.

3) Pre-wet entire spall with 10 Minute Concrete Mender™.

4) Immediately add 1/2" of silica sand and completely saturate with 10 Minute Concrete Mender™. Continue in 1/2" lifts. Make certain all of the sand is saturated.

5) Use a margin trowel or taping knife to smooth and shape the sand and material mortar.

6) When material cures (turns light gray in color), scrape off high spots with a sharp scraper. Smooth and finish with a rubbing stone.

7) Finished repair is open for all traffic. Any staining due to over banding will quickly wear off or can be removed with a light sanding.

Tools Required Cartridge Assembly Start-up Procedure Crack and Joint Repair Spall Repair Recapping Partial Cartridges Troubleshooting, Clean-up and Disposal

Home - Products - Applications - Sales Literature - E-mail Roadware

`©2001` Roadware Incorporated, All Rights Reserved, The information within this website is for the sole use of Roadware customers and interested parties. Alteration and duplication is prohibited without written consent from Roadware, Inc.

1) Clean repair area. Remove all dirt, oils, and loose debris. Make a 1/4" relief cut with grinder.
2) Remove any dust with a vacuum or compressed air.
3) Pre-wet entire spall with 10 Minute Concrete Mender™.
4) Immediately add 1/2" of silica sand and completely saturate with 10 Minute Concrete Mender™. Continue in 1/2" lifts. Make certain all of the sand is saturated.
5) Use a margin trowel or taping knife to smooth and shape the sand and material mortar.
6) When material cures (turns light gray in color), scrape off high spots with a sharp scraper. Smooth and finish with a rubbing stone.
7) Finished repair is open for all traffic. Any staining due to over banding will quickly wear off or can be removed with a light sanding.

ROADWARE 10 CONCRETE MENDER™

300ML X 300ML CARTRIDGE APPLICATION INSTRUCTIONS

Spall Repair

©2001 Roadware Incorporated, All Rights Reserved, The information within this website is for the sole use of Roadware customers and interested parties. Alteration and duplication is prohibited without written consent from Roadware, Inc.

Please direct comments or questions regarding this website to the Roadware Webmaster.

`©2001` Roadware Incorporated, All Rights Reserved, The information within this website is for the sole use of Roadware customers and interested parties. Alteration and duplication is prohibited without written consent from Roadware, Inc.