ROADWARE 10 CONCRETE MENDER™ 300ML X 300ML CARTRIDGE APPLICATION INSTRUCTIONS
	Home - Products - Applications - Sales Literature - E-mail Roadware
Tools Required Cartridge Assembly Start-up Procedure Crack and Joint Repair Spall Repair  Recapping Partial Cartridges Troubleshooting, Clean-up and Disposal

Crack and Spalled Control Joint Repair

1) Clean repair area. Remove all dirt, oils, and loose debris.
2) Remove any dust with a vacuum or compressed air.
3) Fully pre-wet sides and bottom of crack with 10 Minute Concrete Mender™.
4) Immediately add up to 1/2" of silica sand and more 10 Minute Concrete Mender™. Work in 1/2" lifts. Add enough material to slightly overfill the repair. Use enough liquid to COMPLETELY SATURATE THE SAND.
5) Use a margin trowel or taping knife to smooth and shape the sand and material mortar.
6) When material cures (turns light gray in color), scrape off over banding with a sharp scraper.
7) Finished repair is open for all traffic. Any staining due to over banding will quickly wear off or can be removed with a light sanding.

Tools Required

Cartridge Assembly

Start-up Procedure

Crack and Joint Repair

Spall Repair

Recapping Partial Cartridges

Troubleshooting, Clean-up and Disposal

Home - Products - Applications - Sales Literature - E-mail Roadware

©2001 Roadware Incorporated, All Rights Reserved, The information within this website is for the sole use of Roadware customers and interested parties. Alteration and duplication is prohibited without written consent from Roadware, Inc.